Installing 12v LED lights is a fairly simple process. It may not be necessary but I feel better having created an air gap like this.Īfter this was created, the next step was to wire up all of the lights. This is just a precautionary measure that I took to make myself feel better. It created a small air gap so that any heat coming from the lights could be dissipated before reaching any kind of material. This allowed me to push the insulation up at each light location so that it did not touch the light. To do this, I cut some small pieces of wood and glued them on the upper side of the ceiling where the holes are. I realize that LED lights do not put off a lot of heat but during my testing, I did notice at least some heat coming from them. At the time, I was not sure how hot these lights would get so I wanted to be sure that nothing will overheat and catch fire. Once I came to a location that required a hole for a light, I drilled the hole after I had measured my cedar plank.Īfter the cedar planks were all installed, I had a finished ceiling with six holes throughout the living area that all had wires ready to be connected.īefore installing the lights and connecting the wires, I wanted to make sure that there was enough air gap so that the lights would not be touching the insulation. I had marked the location of each light on the ceiling before installing my cedar planks. I cut these holes during the process of installing the cedar planks on the ceiling. This type of drill bit is great because it creates a very clean cut and bores through the cedar wood ceiling as if you are cutting through butter. These can easily be drilled using a Forstner bit. You will need to drill 2 1/4 inch holes for the lights to fit into. The installation of these lights is pretty simple. They have a lot going for them and I highly recommend them. Of course, Acegoo isn’t the only option available but these lights are tried and true in the van conversion community. Each light weighs approximately 1.6 ounces (46g). I ended up using only 7 of the lights so I had one left over.Īs you can see from the image below, these lights measure in at 2 3/4 inches in diameter. With a total of eight lights to work with, I had plenty to get the job done with sufficient lighting for my entire van. Likely, you will not need very many of them to complete a well-lit area within your van conversion. These lights are very bright for their size and energy usage. You can also choose white if that is what you prefer. I personally like the silver look against the cedar wood planks that I used on my ceiling. Acegoo has different types of light configurations but I chose to use the recessed LED lights in silver. Products I UsedĪcegoo LED lights have become a popular choice for camper van conversions and for a good reason they make great lights since they are small, lightweight, use very little energy, and look great. Before I get into the details of how I designed and installed my lighting system, let’s look at the products I chose for the job. This is exactly what I chose to do in my van. ![]() ![]() In my opinion, the perfect solution is to utilize LED technology with dimmer switches so that you can control the amount of brightness in the van. Too much lighting and you’ll feel like you are living on the sun but too little lighting can make your tiny space feel even more depressing. A camper van can be quite small so choosing the right kind of lighting can make all the difference. ![]() ![]() Installing lights in a conversion van is a necessary step if you want to have sufficient lighting to brighten the living space up. This means that I may earn a small commission if you click on them and make a purchase. Disclosure: Some of the links in the article below may be affiliate links.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |